Project Responsible for Development of Electronics Control Units for Vehicle Motion Brakes SystemsCandidate is responsible for the activities:Requirements Analysis.Project Planning, tracking and executionDelivering the technical documents viz., Schematic and BOM to plant.Perform Calculation for interface circuit to the ECU.Should we able to understand the EMC, Safety, and environmental standards.Interact with SW team to fix the thresholds.Interaction with stakeholders (Both internal and external to Organization).To sum up the candidate will be an interface to customer from ECU electronic HW perspective. Additional informationExperience in verification techniques (design verification methods, data. acquisition/analysis, hardware-in-the-loop virtual tools (HIL/MIL/SIL).Experience with model-based design: Matlab/Simulink/Stateflow.Understanding of typical automotive interfaces: CAN, CANFD, Flex ray, Auto-Ethernet, etc.Understanding of Functional Safety (ISO 26262) & Failure Mode Avoidance.Experience with rapid prototyping.Familiarity with Vector CANape, CANalyzer.Ability to work independently and take initiative when necessary.Strong communication, written, oral, and interpersonal skills.High attention to detail, accountability, and ownership.Full life cycle Hardware development experience for automotive electronics productsProject management experience.Experience working on a Global, cross-functional project.Technical understanding of the electronic circuit and design of electronics modules.